1600 HF Timing Chain Tensioner

[bmarler]

i have seen this type of bushing before, mostly used to correct any difference in bearing sizes. not a good solution IMHO. just hardening a new pin is only part of the answer. you also need some sort of bearing surface as well. i might suggest boring the arm and pressing in a bronze busing as well.

[racing]

second try not received.
look at Fulvia register running nr. 19 with new end @zf.com instead sachs.de.

regards
Andreas

[lanciagarage]

Hi andreas, I don't know why your messages are not getting to you. I will try a "test" one again.

Please give me that site address again, I can't work out what you put in the post.

Regards
Phil

[racing]

Hi Phil,

try andreas.tantius@zf.com

regards

Andreas

[lanciagarage]

Hi Andreas,

I'll send you a mail later in the week when I get a chance.

Regards
Phil