International Lancia Forums

Hi,
Does anyone have detailed pictures of the Lancia Flavia Convertible trunk construction that includes the rear cross beam (adjacent to trunk latch) and the structural sections that tie into it. Also the trunk floor outer edge adjacent to the rear fender.

Thanks,

Brian

Hi bmw8890, try to take a look of the following pictures set:

https://www.flickr.com/photos/108595436 ... 736374754/

Those picture have been a great help but I am trying to get more detail of the beam section of the trunk adjacent to the fenders. The pictures clearly show a beam/stiffener but I need to see the under side to figure it out

Hi,

please find attached a couple of picture of trunk right side zone of my car, with an upper upper and bottom view.

I hope can help you, if you need to magnify some details please mark it in the picture and I'll try to do a better shot.

.. just another picture

Can you send a pictures of the other side of both inside and underside? Thanks for the pictures that you sent.

left side, here they are....ciao.

Perfect...thanks,

Brian

looking for a picture under the trunk of the wall that attaches to the fender as shown in the attached file. Not sure how it attaches to the back section of the trunk rear support.

Thanks,

brian

Ciao Brian, the fender is attached in the support upper side by the brackets and bolts visible in the pictures I've alredy posted here; from the bottom you can't see anythings.