ph11 turbo serious misfire when cold.
ph11 turbo serious misfire when cold.
when i start the car from cold it starts fine, but when you go to accelerate the car picks up no speed and it vibrates excessively, and it tries to stall when you pull up to a stop. when the car is warm it runs fine apart from it occasionally stalls when you pull up. it has had full engine diagnostics done, and all the paramaters are within specifications. have you had this problem before or do you have any ideas? cheers........
Re: ph11 turbo serious misfire when cold.
hi
i have the same problem, maybe not so excessively as you say but there are vibrations acceletrating from zero. i tried to change the silentblocks but the problem still there. i also have done distribution. maybe the transsmision ???
bye
i have the same problem, maybe not so excessively as you say but there are vibrations acceletrating from zero. i tried to change the silentblocks but the problem still there. i also have done distribution. maybe the transsmision ???
bye
Re: ph11 turbo serious misfire when cold.
This sounds like fuel feed problem, either dodgy pump or choked filter. The water temperature sensor is the usual cause of most faults - either its self or the wiring to it. However if the diagnostics checked out then it must be OK.
Good luck, Leo
Good luck, Leo