Page 1 of 1
Heater intake duct alignment
Posted: 28 Jul 2007, 13:53
by Michael Beattie
I have noticed that the heater duct in the engine bay is slightly higher on one side than the other, which is distorting the bonnet slightly.
Is it possible to easily remove this duct, so that I can adjust its alignment ?
Re: Heater intake duct alignment
Posted: 28 Jul 2007, 19:51
by Paul de R. Leclercq
Yes, a piece of cake.
Remove the two rubber bungs on the front and you will have access to two 10mm nuts that secure the duct to the bulkhead. You will need a reasonably long extension and 10mm socket; as is the norm on Fulvias 1/4" or 3/8" drive is best.
Paul
Re: Heater intake duct alignment
Posted: 28 Jul 2007, 20:16
by Michael Beattie
Paul
Many thanks, job done !
Michael
Re: Heater intake duct alignment
Posted: 28 Jul 2007, 22:33
by Paul de R. Leclercq
You are welcome
P.