Page 1 of 1
Series 2 steering linkage joints
Posted: 14 Sep 2005, 08:23
by Christopher Adams
Looking at the series 2 series (fine thread) linkage joints they appear to be exactly the same as used in a Fiat 125. The Fiat 125 only comes with RH threads. Can anyone confirm that the 125 joints are the same, and also confirm if there are any other applications where the equivalent joints, but with a LH thread were used?
Chris
Re: Series 2 steering linkage joints
Posted: 15 Sep 2005, 14:19
by Paul de Raymond Leclercq
You may well be right about this. I cannot help on the LH thread version, but the Fulvia joints are not difficult to get.
You might care to know that the SII top ball joint is a FIAT 125 bottom one!
Paul
Re: Series 2 steering linkage joints
Posted: 16 Sep 2005, 08:52
by Christopher Adams
Thanks, I knew about the ball joint from the 125. Re. the steering linkages I know they are stocked at Omicron, I was just looking for a shortcut to avoid the frieght charges to airmail 1/2 way round the world.
There is an upcoming Lancia Rally October 14th here in Australia with Sandro Munari as guest of honour. Despite being offered a Thema 8.32 to drive down for the event, I can't make it due to a friends wedding....very sad.
Chris