International Lancia Forums

Firstly, thanks to all those who replied to my request for Flavia Coupe parts. I am investigating various ways of refurbishing the exterior plated parts from the Pininfarina Coupe and was looking at the rather sad headlight bezels on both of the cars I am working on. CNC machining from aluminium is a possibility and I was wondering if there was any interest in a small batch run that would require polishing and plating? This part does not seem to appear on Cavallito's list but if there is a ready supply of replatable second hand units it may not be worth further investigation. Any thoughts?

HI
Most of the ones that i have seen are broken around the screw hole on the bottom of the unit, and they do pit quite alot. so i would be interested in some new ones.
regards
Russell

Thanks for the interest. I am looking at various ways of reproducing this part and will keep the list informed of progress.

Cheers,

Michael
'Squadra Port'