Lancia Flavia 1800 coupe restoration
Posted: 13 Feb 2007, 03:00
I have recently started on the restoration of two Flavia coupes, both early model 1800s, single carb and strip speedometer. I am looking for the following parts for a RHD car and have approached various suppliers and individuals who may also view this forum from time to time. If anyone else can help with either parts or advice, I would be grateful to hear back. Also, has anyone used Reoriginals for a set of rubber mats for the Flavia coupe? They have them listed on the site but no reply to enquiries as yet. Here is the list as it stands...
Passenger (left side) seat
Driver's side door glass and internal frames
Driver's side rear quarter light and fixings
Driver's door exterior handle
Passenger's side door glass and internal frames
Passenger's side rear quarter light and fixings
Rear bumper
Boot external handle
Trim from rear wing top seam (both sides)
Oil cooler
Air cleaner chamber
Pininfarina badges from lower wing
Boot script
Both cars have cracked front screens and I am looking for replacements for these with seals also.
Kind regards
Michael Findlay
'Squadra Port'
Port Chalmers
New Zealand
Passenger (left side) seat
Driver's side door glass and internal frames
Driver's side rear quarter light and fixings
Driver's door exterior handle
Passenger's side door glass and internal frames
Passenger's side rear quarter light and fixings
Rear bumper
Boot external handle
Trim from rear wing top seam (both sides)
Oil cooler
Air cleaner chamber
Pininfarina badges from lower wing
Boot script
Both cars have cracked front screens and I am looking for replacements for these with seals also.
Kind regards
Michael Findlay
'Squadra Port'
Port Chalmers
New Zealand