Aurelia B12 Cylinder Liner O-Rings
Posted: 08 Oct 2004, 12:18
Hello,
does anybody know the diameter (cross section) of the two rubber O-rings that seal the cylinder liners.
The (deformed?) originals are 4 mm * 3 mm and almost square. So I tried 4 * 4 mm but they are very tight.
Any hint would be valuable to me.
Thanks,
Norbert
.
does anybody know the diameter (cross section) of the two rubber O-rings that seal the cylinder liners.
The (deformed?) originals are 4 mm * 3 mm and almost square. So I tried 4 * 4 mm but they are very tight.
Any hint would be valuable to me.
Thanks,
Norbert
.