How to open the Fulvia's 2nd gen Steering Box
How to open the Fulvia's 2nd gen Steering Box
Ciao, anyone does know how to open the Lancia Fulvia's steering box as
shown in the picture?? I am a little bit lost ..
Re: How to open the Fulvia's 2nd gen Steering Box
Several options:
1. Eat a lot of spinach
2. The 5 people method. Two hold the table in place. Nr 3 holds the tool on the nut. Nr 4 puts an extension on the tool and applies fource. Nr 5 hammers the nut. Remember that small guy with big hammer achieve more than big guy with small hammer.
3. Use a half inch high power impact tool. Make sure the compressor delivers enough air at 7 bar or more.
If you use impact tools (hammer is one too) make sure the stationary part (in this case the box) has enough mass or is solidly attached to lots of mass. We use a vey heavy table of 1 cm thick steel with a huge vice.
1. Eat a lot of spinach
2. The 5 people method. Two hold the table in place. Nr 3 holds the tool on the nut. Nr 4 puts an extension on the tool and applies fource. Nr 5 hammers the nut. Remember that small guy with big hammer achieve more than big guy with small hammer.
3. Use a half inch high power impact tool. Make sure the compressor delivers enough air at 7 bar or more.
If you use impact tools (hammer is one too) make sure the stationary part (in this case the box) has enough mass or is solidly attached to lots of mass. We use a vey heavy table of 1 cm thick steel with a huge vice.
Re: How to open the Fulvia's 2nd gen Steering Box
Ok I will try with a hairdryer first