International Lancia Forums

I'm new to the forum, but this seems to be the most active place for Lancia's online.
I've been slowly working on a 1972 Fulvia 1.3S restoration for the last 4 years and this is one of the last few problems to figure out.

I'm looking for this panel, it can be a new old stock part, but the more likely solution is to find someone with a junk Fulvia parts car and have them cut this panel out. Its the support under the trunk floor that the panhard bar attaches to.

So if anyone has one or has a car to cut one out of, please reach out to me, so we can make deal.
I will pay for the shipping to Canada.

Thanks
Mark

Hi Mark

First time I see one on such a bad condition. We would reproduce or repair such a part.

Car was outside and water was leaking into the truck and it must have been parked with the left side lower down, such that the drain hole didn't help. If it comes to fabricating such a part, I would do it myself. However it is 14 gauge and would be real effort to make it look like it was home made. I'm sure there is a scrap yard out there, that could cut a decent one out of a car in a matter of minutes with a torch.