International Lancia Forums

My problem is that i don't know how to connect hoses under the hood, problem is with this hoses which
brings the gas vapor to the engine, i don't know that are the hoses correctly connected.
Here are the pictures.
http://www.zone.ee/ohvroad/lancia%20023.jpg?2
http://www.zone.ee/ohvroad/lancia%20026.jpg?2
http://www.zone.ee/ohvroad/lancia%20037.jpg?2
http://www.zone.ee/ohvroad/lancia%20012.jpg?2
And there is one end on what no hose go on, the picture is here
http://www.zone.ee/ohvroad/lancia%20033.jpg?2
Also i have looked for help in Estonia but there is no one who could help me, so i hope that i will get help here.

Hello Matis,
Sorry I cannot help with the engine bits. Your engine looks like a single camshaft 1600 as used in the Dedra and some Fiats. In the UK the 1.6GTie has a twin camshaft engine.
I can help with the last picture (033). The plastic container is a vacuum reservoir and the missing pipe would connect to the heater blower control switch. The switch has a valve assembly as well as the contacts for the blower motor. The valve connects the vacuum circuit to the flaps on the heater assembly - you can see the actuator on top of the heater unit under the bonnet. If you cannot find the small rubber pipe, open the flap by hand and leave it open, the heater will work OK.I have put a diagram here
picture here
If link not working try www.lancisti.org the Photo Gallery then members A-M (look for A1.6HPE)

Try a FIAT forum for the engine pipes.

Good luck, Leo (sorry I do not speak your language)