Search found 74 matches
- 24 Nov 2021, 08:24
- Forum: NL85 Fulvia, Flavia, Flaminia, Stratos
- Topic: Aktiemodel Fulvia coupe ?
- Replies: 1
- Views: 1303
Re: Aktiemodel Fulvia coupe ?
Ik vond deze fabrieksfoto
- 23 Nov 2021, 19:23
- Forum: 65 Fulvia
- Topic: Series 1 starter questions
- Replies: 4
- Views: 790
Re: Series 1 starter questions
Thanks you, I will take the starter out and clean/ lubricate bendix to see if it fixes it.
- 14 Nov 2021, 01:32
- Forum: 65 Fulvia
- Topic: Series 1 starter questions
- Replies: 4
- Views: 790
Re: Series 1 starter questions
Pics of Bosch starter
- 14 Nov 2021, 01:28
- Forum: 65 Fulvia
- Topic: Series 1 starter questions
- Replies: 4
- Views: 790
Series 1 starter questions
My Series 1 Fulvia coupe is developing an intermittent issue where the starter would keep running after I release the key. Plan is to start by cleaning/ sericing the ignition switch and lubricating it with some graphite powder. If this fails, can it be due to the starter relay failing? Also looking ...
- 16 Oct 2021, 11:06
- Forum: 65 Fulvia
- Topic: S1 headlight units - are LHD and RHD the same?
- Replies: 2
- Views: 668
Re: S1 headlight units - are LHD and RHD the same?
Picture attached.
- 16 Oct 2021, 05:49
- Forum: 65 Fulvia
- Topic: S1 headlight units - are LHD and RHD the same?
- Replies: 2
- Views: 668
S1 headlight units - are LHD and RHD the same?
One of my outer headlights on my S1 coupe (RHD) turned a bit yellow so I am looking to replace it (or both sides) with another original Siem unit. There are a few new ones available on ebay etc in Europe but I am not sure if LHD and RHD units are the same (the light only, not the "cup"). I...
- 27 Jun 2021, 10:38
- Forum: 65 Fulvia
- Topic: Sump Capacity
- Replies: 4
- Views: 1301
Re: Sump Capacity
I once had a Fulvia dipstick where the cap part came loose and could slide along the dipstick. That yielded some confusing measurements! Welded it back in place where the old weld mark was and all was good again.
- 10 Mar 2021, 09:28
- Forum: 65 Fulvia
- Topic: Float level 1.3 Fulvia
- Replies: 12
- Views: 2183
Re: Float level 1.3 Fulvia
The one carb's float level was sitting at 19mm and the other at 21mm, hence why they appeared to be quite different to the eye. Not too bad though and with a bit of effort got them both to exactly 20mm. Just another question after checking the jets over again, what is the third jet at the bottom of ...
- 09 Mar 2021, 07:11
- Forum: 65 Fulvia
- Topic: Float level 1.3 Fulvia
- Replies: 12
- Views: 2183
Re: Float level 1.3 Fulvia
Thank you, that is great information. Yes, the car had a oil bath filter since new, but I have removed it and fitted a standard air filter. When I checked the jets I noticed that there should be different jets for the different air filters, but the ones fitted were the same as for the standard air f...
- 08 Mar 2021, 22:39
- Forum: 65 Fulvia
- Topic: Float level 1.3 Fulvia
- Replies: 12
- Views: 2183
Re: Float level 1.3 Fulvia
Thanks - It is for S1 1.3 Rallye S, 818.303 engine.
PHH13 carbs, currently on car.
PHH13 carbs, currently on car.