http://www.carparts-pros.com , teile nr 60680252, 202,80€

Es ist besser, vor der Bestellung zu fragen, weil ihre Listen nicht genau sind.

Wunderbar!

And yes, there are two versions, yours seems to be 60659871 then.

If I'm correct, it should be this one, part no 156038674? https://www.autosklep24.pl/pl/p/Kolpak-kola-LANCIA-THESIS-maly-16/10179 Other source: https://en.partacus.de/spareparts/detail/Fiat-original-156038674-RADKAPPE+-2-687946cd3780d59f9396050dd236938a/ And this shows it also: http://www.teile-prof...

I understood that whole lower rear arm (with 3 bushes) needed replacing? Yep, those are expensive parts, over 400€/piece when new. If similar repair occurs to other side, there are possibility to replace bushings only with a fraction of costs by using original type bushes or polyurethane ones. I kno...

That's it, plus you can use it as handsfree system if you just add microphone.

https://loudlink.eu/webshop/

Hi, entschuldigen Sie, mein Deutsch ist sehr schlecht, so I write this in English. I had similar problems and I had to change upper arms, for example. The easiest way is to drop rear axle down, but it can be done within two hours (even alone) if you can use proper car lift (I used 2-pillar lift). Re...

Hi, I had similar problem on passenger side due to small accident. Here is a picture of straight one on driver's side. As you can see, bottom part is flat with front frame: https://imgur.com/bsB8WY2 here was the bent one: https://imgur.com/xQof1Ae The easiest way to bend those is to remove arm compl...

I am also missing both of those plates. Or I have them "somewhere" but I couldn't figure them out how on earth they're holding there or working with headlight. They disintegrated every time I tried to place headlight back to its place. But headlights have stayed there even I've removed the...

This one?

http://www.ebay.de/itm/Lancia-Thesis-Sc ... 2336492884

Repair update: left rear light was again acting wrong so I made quick'n dirty repair work. I noticed that one wire caused all problems when twisting it a bit. So, some solder work was required. I used dremel for cutting a hole, which then eliminated the need for complete disassembly. Black wire unde...